Mitsubishi Electric Error Code E191 Diagnostic & Repair Guide
System fault detected on Mitsubishi Electric equipment triggering diagnostic alert code E191.
Equipment TypeMini-Split & Multi-Split Heat PumpsBrand: Mitsubishi Electric
Fault SeverityModerateSystem Lockout Active
Estimated Repair Cost$90 โ $420Parts & Certified Labor
๐จ Symptoms of Mitsubishi Electric Error E191
- Mitsubishi Electric controller displays error code E191
- Heating, cooling, or domestic hot water operation interrupted
- Status indicator light flashing warning pattern
๐ Root Causes for Mitsubishi Electric Code E191
- Sensor out of calibration or open/short circuit on Mitsubishi Electric PCB
- Airflow or refrigerant pressure abnormality
- Interrupted electrical power or communication wiring fault
- Mechanical component wearing or safety limit tripped
๐ ๏ธ How to Reset & Troubleshoot Mitsubishi Electric Error E191
- Perform a power cycle reset by turning off the system circuit breaker for 5 minutes
- Inspect and clean air filters or water strainers to ensure unrestricted flow
- Check for error recurrence and note any strange motor sounds or clicking
- Consult Mitsubishi Electric certified technician if code returns immediately after reset
Frequently Asked Questions โ Mitsubishi Electric Code E191
What does Mitsubishi Electric error code E191 mean?
Mitsubishi Electric code E191 indicates: System fault detected on Mitsubishi Electric equipment triggering diagnostic alert code E191.
How do I reset error code E191 on Mitsubishi Electric?
Turn off the electrical circuit breaker or isolator to the unit for at least 5 minutes to discharge the capacitors and reset the microprocessor. If the code reappears immediately upon restarting, professional inspection is required.
What causes error code E191 on Mitsubishi Electric systems?
Common triggers include: Sensor out of calibration or open/short circuit on Mitsubishi Electric PCB, Airflow or refrigerant pressure abnormality, Interrupted electrical power or communication wiring fault.