Mitsubishi Electric Error Code E671 Diagnostic & Repair Guide
System fault detected on Mitsubishi Electric equipment triggering diagnostic alert code E671.
Equipment TypeMini-Split & Multi-Split Heat PumpsBrand: Mitsubishi Electric
Fault SeverityModerateSystem Lockout Active
Estimated Repair Cost$90 โ $420Parts & Certified Labor
๐จ Symptoms of Mitsubishi Electric Error E671
- Mitsubishi Electric controller displays error code E671
- Heating, cooling, or domestic hot water operation interrupted
- Status indicator light flashing warning pattern
๐ Root Causes for Mitsubishi Electric Code E671
- Sensor out of calibration or open/short circuit on Mitsubishi Electric PCB
- Airflow or refrigerant pressure abnormality
- Interrupted electrical power or communication wiring fault
- Mechanical component wearing or safety limit tripped
๐ ๏ธ How to Reset & Troubleshoot Mitsubishi Electric Error E671
- Perform a power cycle reset by turning off the system circuit breaker for 5 minutes
- Inspect and clean air filters or water strainers to ensure unrestricted flow
- Check for error recurrence and note any strange motor sounds or clicking
- Consult Mitsubishi Electric certified technician if code returns immediately after reset
Frequently Asked Questions โ Mitsubishi Electric Code E671
What does Mitsubishi Electric error code E671 mean?
Mitsubishi Electric code E671 indicates: System fault detected on Mitsubishi Electric equipment triggering diagnostic alert code E671.
How do I reset error code E671 on Mitsubishi Electric?
Turn off the electrical circuit breaker or isolator to the unit for at least 5 minutes to discharge the capacitors and reset the microprocessor. If the code reappears immediately upon restarting, professional inspection is required.
What causes error code E671 on Mitsubishi Electric systems?
Common triggers include: Sensor out of calibration or open/short circuit on Mitsubishi Electric PCB, Airflow or refrigerant pressure abnormality, Interrupted electrical power or communication wiring fault.